英语翻译Table 2 and Fig.3 show the influences of particle size and contents of PEG onmorphology of TiO2 film.Pore size and porosity increased with the amount of theadded PEG.The SEM images (Fig.4) also confirmed these phenomena.The shapeand size

来源：学生作业帮助网编辑：作业帮时间：2024/04/30 10:30:26

英语翻译Table 2 and Fig.3 show the influences of particle size and contents of PEG onmorphology of TiO2 film.Pore size and porosity increased with the amount of theadded PEG.The SEM images (Fig.4) also confirmed these phenomena.The shapeand size
英语翻译
Table 2 and Fig.3 show the influences of particle size and contents of PEG on
morphology of TiO2 film.Pore size and porosity increased with the amount of the
added PEG.The SEM images (Fig.4) also confirmed these phenomena.The shape
and size of TiO2 crystallites did not change with the addition of PEG.In addition,
Fig.5 shows that roughness factor (rf) and porosity of the film changed linearly with
the amount of PEG.While TiO2 particles in the sol were surrounded by adsorbed
PEG molecules under the low concentration conditions,in the very high
concentration conditions,excess amount of the PEG seems to exist as large
aggregates in the sol.Therefore,larger pores should be formed in the film during the
sintering process with the increase of PEG.
The roughness factor (rf) of T iO2 film decreased as the particle size of TiO2
crystallites increased.The average pore size and porosity of the film decreased with
decreasing particle size because the void between the particles became smaller with
the decrease of the particle size.The mesoporous film became more brittle when the
concentration of PEG was higher than 50 wt%:From these results,we found that
pore size,porosity and effective area of the mesoporous film could be precisely
controlled by combination of the autoclaving temperature for the sol preparation
and the amount of PEG in the paste.

英语翻译Table 2 and Fig.3 show the influences of particle size and contents of PEG onmorphology of TiO2 film.Pore size and porosity increased with the amount of theadded PEG.The SEM images (Fig.4) also confirmed these phenomena.The shapeand size
表2和图.3显示的影响粒子的大小和内容,就挂
形态的二氧化钛薄膜.孔径大小和孔隙率增加与金额的
补充挂.扫描电镜图像（图4 ）也证实了这种现象.形状
和大小的二氧化钛晶体,没有改变,与另外的PEG .此外,
图.5可以看出,粗糙度因子（ RF ）及孔隙度的电影改变了线性
额的比值.而二氧化钛粒子溶胶四周吸附
聚乙二醇分子在低浓度条件下,在非常高
浓度条件下,过量的联系汇率制度似乎存在着大
碎石溶胶.因此,较大的孔隙中,要形成在这部影片中,在
烧结过程中随挂.
粗糙度因子（ RF ）的T io2电影下降,颗粒大小的二氧化钛
微晶增加.平均孔径及孔隙度的电影下降
减小颗粒大小,因为这个空档之间颗粒变小,与
减小颗粒尺寸.介孔薄膜变得更加脆当
浓度的PEG高于50 wt ％的：从这些结果,我们发现
孔径大小,孔隙率和有效面积的介孔薄膜,可恰恰
控制相结合的蒸汽温度为溶胶的制备
和数额的PEG在糊.

英语翻译Table 2 and Fig.3 show the influences of particle size and contents of PEG onmorphology of TiO2 film.Pore size and porosity increased with the amount of theadded PEG.The SEM images (Fig.4) also confirmed these phenomena.The shapeand size 英语翻译The result of DME combustionwithout catalyst is shown inFig.S1 (Supplementary data,Fig.S1),whichindicates that thehomogeneous oxidation startsafter 200 °C and the temperaturefor complete conversion is higherthan 525 °C.Fig.1 and Table 1 英语翻译The development of pig embryos originatingfrom enucleolated oocytes arrested after afew cleavages (Table 1 and Fig.3A).In contrast,embryos from sham-operated oocytesdeveloped to blastocysts with detectable nucleoli(fig.S8,Pig).The cleavag 英语翻译A plan of the panel P-31 of seam no.lA of GDK-SA incline is shown in Fig.1.A three dimensional view and plan view of the model showing grid pattern in and around the seam and panel is shown in Fig.2a and b,respectively.Modelling results,i 英语翻译The experimenter sat at a table across from the child and introduced two tools（fig.1）.one tool,the “blicket”,was demonstrated ringing a bell.The blicket was not described ; the experimenter simply called attention to it then perfo 英语翻译Firstly,spindle system in Fig.1 is divided into the number of elements given in Table 1.Then,from the Lagrange equation and the rotor dynamics,the dynamic model of the elements is established using the Timoshenko beam element.Finally,the 英语翻译3.Results and discussion3.1.Water uptake and diffusion coefficientsGravimetric results are presented in Fig.1 were the frac-tional amount of water is plotted against t1/2.In Fig.2,the water content measured by FT-NIR for the different sam 英语翻译Fig.2 shows the INS process..There are two main phases for INS operation:the alignment phase and the navigation phase.The navigation phase starts from the initial velocity,position and attitude.The process for determining these INS initia 英语翻译The System Software Design and AnalysisAs illustrated in fig.2,this system can be divided into the software modules and computersoftware modules.The function of the software is transmissions the CAN busdata through the USB bus to Computer 英语翻译9.2.2 Carbon Fixation and Energy FlowThe ability to photosynthesize allows sunlight energy to be trapped and stored.In this process carbon dioxide is fixed into organic matter (Fig.9.1).Photosynthetic organisms,also called primary produce 英语翻译FIG.2 illustrates a crosssectional view of the packaged IC of FIG.1 at a stage in processing inaccordance with one embodiment of the present disclosure. 英语翻译Table 2 – The charge density and molecular weight ofpolyelectrolytes 英语翻译in fig .1-7c all voltages are marked in the -to+sense in going clockwise around the loop.the voltmeters are connected as shown in fig.1-7d to measure voltages u'1,u'2and u'3.nothing that the voltmeter readings are the same as the variable 英语翻译5.2.Telephone communication and cultural distanceHypothesis 2 was supported.When examining phonecommunication,similar results were observed.As shown in Fig.2,some 40% of the US exporters initiated phonecommunication with their foreign dis 英语翻译The instrumentation comprised EG&G Model 273 Potentiostat/Galvanostatwith IR compensation option,a computer,and a printer.A stainlesssteel frame was used as counter electrode.Fig.2 is a schematic representationof the test setup.The potent 英语翻译there [ ]a watermelon and [ ] [ ] on the table. 英语翻译Experimental results for the magnetic coupling can be seenin Fig.10 where both the load disturbance and torsion angleerrors are corrected for a load-side set-point position-referenced system.Although the results shown in Fig.10 show fast 英语翻译Unpacking(models WMN 642M)1.remove back panel screws and lift panel clear(Fig.A)2.Remove fixing screws from the four brackets to cross bearing (Fig.B) and remove brackets.3.Fix back panel with 3 screws previously removed (Fig.C)4.Close th